Nail Art Slider Kodi Professional

Apply a base coat to the prepared nail plate and cure it under a lamp.
Apply the desired number of layers of color coat (preferably lighter shades) and cure each layer under the lamp.
Apply a thin layer of top coat with a sticky layer over the color coat and cure it. Do not remove the sticky layer. Cut out the desired design from the set, leaving as much clear film as possible around the perimeter (do not cut right up to the design). This allows for better adhesion to the nail plate. Submerge the design in warm water for 5-10 seconds until the film becomes movable. Dab off any excess water with a tissue to ensure the film is dry. Carefully slide the design off its paper backing and place it onto the sticky layer of the top coat, positioning it as desired. Smooth out any wrinkles with a tissue and gently press down.

If there are any excess film pieces, trim them off with scissors. Remove any excess at the free edge using a nail file. Use a fine brush to apply a top coat around the edges of the design, creating a border. Cure it under the lamp. If you are using a 3D stone with a foiled oval, create a volumetric drop on the foiled part using top coat, base coat, or structural gel (whichever is thicker), and cure it for slightly longer than usual.

Apply a final thin layer of top coat over the entire nail and cure it again. If the top coat has a sticky layer, remove it with a cleanser.