- Product details
- How to use
-
Age:
18+
Classification: professional
Country: USA
Made in: USA
-
Apply a base coat to the prepared nail plate and cure it under a lamp.
Apply the colored coat in the necessary number of layers (lighter shades are recommended). Cure each layer under the lamp.
Apply a thin layer of top coat with a sticky layer over the color, cure it, and do not remove the sticky layer. Cut out the desired design from the set. Try to leave as much clear film around the perimeter as possible (do not cut exactly along the edge of the design). This ensures better adhesion to the nail plate. Dip the cutout into warm water for 5-10 seconds until the film becomes movable. Blot away excess moisture with a tissue to remove any water from the film. Carefully slide the design off the paper backing. Place the design on the sticky layer of the top coat, positioning it as desired. Smooth out any wrinkles with a tissue and gently press down.If there are excess film pieces, you can remove them with scissors, and any excess at the free edge can be filed off. Using a fine brush, apply top coat around the design to create a seal. Cure it. If you're using a 3D stone (with a foiled oval), create a volumetric drop on the foiled part using top coat, base coat, or structural gel (whichever is thicker) and cure it for a bit longer than usual.
Apply a thin final layer of top coat over the entire nail and cure it again. If the top coat has a sticky layer, remove it using a cleanser.